Creating a new point feature using a 1 point offset
Release 8 E-mail This Topic Printable Version Give Us Feedback

  1. Make the point layer editable using the Start/Stop Editing tool.

  2. Tap the drop-down arrow next to the Offset Point button to display the drop-down list. By default, the Offset Point button is displayed on the Edit toolbar.
  3. Tap the Offset Point button.
  4. Tap Set Reference Point A.

    A red box around the Offset Point and Set Reference Point A buttons indicates that they are active.
  5. Tap the screen to set reference point A.
    Tip
    Using a GPS to set the reference points: ArcPad will automatically use the current GPS position for the reference point if data is received from a rangefinder and there is no current reference point defined, and either Offset Point, Linear Traverse, or Radial Traverse are enabled.
  6. Tap the Point feature button.
  7. If you have a rangefinder activated, shoot your target or simply tap the screen at the location of your feature.

    The Point/Vertex dialog box opens on the Offset page.
  8. Verify that the information in the fields is accurate. .

  9. Tap OK

    The Feature Properties dialog box is displayed with an edit form, if it exists. Enter the information for the new feature.
  10. Tap OK.

    Your new feature is created.

    Note
    Refer to section, Using your rangefinder for information on how to use your rangefinder with ArcPad.